Impact of Annealing Treatment on the Behaviour of Titanium Dioxide Nanotube Layers - Institut de Chimie de Clermont-Ferrand Accéder directement au contenu
Article Dans Une Revue Journal of Biomaterials and Nanobiotechnology Année : 2016

Impact of Annealing Treatment on the Behaviour of Titanium Dioxide Nanotube Layers

Résumé

In this work, we study the influence of the annealing treatment on the behaviour of titanium dioxide nanotube layers. The heat treatment protocol is actually the key parameter to induce stable oxide layers and needs to be better understood. Nanotube layers were prepared by electrochemi-cal anodization of Ti foil in 0.4 wt% hydrofluoric acid solution during 20 minutes and then an-nealed in air atmosphere. In-situ X-ray diffraction analysis, coupled with thermogravimetry, gives us an inside on the oxidation behaviour of titanium dioxide nanotube layers compared to bulk reference samples. Structural studies were performed at 700˚C for 12 h in order to follow the time consequences on the oxidation of the material, in sufficient stability conditions. In-situ XRD brought to light that the amorphous oxide layer induced by anodization is responsible for the simultaneous growths of anatase and rutile phase during the first 30 minutes of annealing while the bulk sample oxidation leads to the nucleation of a small amount of anatase TiO2. The initial amorphous oxide layer created by anodization is also responsible for the delay in crystallization compared to the bulk sample. Thermogravimetric analysis exhibits parabolic shape of the mass gain for both anodized and bulk sample; this kinetics is caused by the formation of a rutile external protective layer, as depicted by the associated in-situ XRD diffractograms. We recorded that titanium dioxide nanotube layers exhibit a lower mean mass gain than the bulk, because of the presence of an initial amorphous oxide layer on anodized samples. In-situ XRD results also provide accurate information concerning the sub-layers behavior during the annealing treatment for the bulk and nanostructured layer. Anatase crystallites are mainly localized at the interface oxide layer-metal and the rutile is at the external interface. Sample surface topography was characte-* Corresponding author. M. Siampiringue et al. 143 rized using scanning electron microscopy (SEM). As a probe of the photoactivity of the annealed TiO 2 nanotube layers, degradation of an acid orange 7 (AO7) dye solution and 4-chlorophenol under UV irradiation (at 365 nm) were performed. Such titanium dioxide nanotube layers show an efficient photocatalytic activity and the analytical results confirm the degradation mechanism of the 4-chlorophenol reported elsewhere.

Domaines

Chimie
Fichier principal
Vignette du fichier
JBNB_2016MS.pdf (1.47 Mo) Télécharger le fichier
Origine : Fichiers éditeurs autorisés sur une archive ouverte
Loading...

Dates et versions

hal-01829439 , version 1 (04-07-2018)

Identifiants

Citer

Marie Siampiringue, Christophe Massard, Eric Caudron, Yves Sibaud, Mohammed Sarakha, et al.. Impact of Annealing Treatment on the Behaviour of Titanium Dioxide Nanotube Layers. Journal of Biomaterials and Nanobiotechnology, 2016, 07 (03), pp.142 - 153. ⟨10.4236/jbnb.2016.73015⟩. ⟨hal-01829439⟩
183 Consultations
215 Téléchargements

Altmetric

Partager

Gmail Facebook X LinkedIn More