Using metal oxide gas sensors to estimate the emission rates and locations of methane leaks in an industrial site: assessment with controlled methane releases - Laboratoire des Sciences du Climat et de l’Environnement Accéder directement au contenu
Article Dans Une Revue Atmospheric Measurement Techniques Année : 2024

Using metal oxide gas sensors to estimate the emission rates and locations of methane leaks in an industrial site: assessment with controlled methane releases

Christopher Caldow
Ford Cropley
  • Fonction : Auteur
Diego Santaren
  • Fonction : Auteur
Adil Shah
Cécile Mallet
Catherine Juery
  • Fonction : Auteur
Olivier Duclaux
Caroline Bouchet
  • Fonction : Auteur
Elisa Allegrini
  • Fonction : Auteur
Hervé Utard
  • Fonction : Auteur

Résumé

Abstract. Fugitive methane (CH4) emissions occur in the whole chain of oil and gas production, including from extraction, transportation, storage, and distribution. Such emissions are usually detected and quantified by conducting surveys as close as possible to the source location. However, these surveys are labour-intensive, are costly, and fail to not provide continuous emissions monitoring. The deployment of permanent sensor networks in the vicinity of industrial CH4 emitting facilities would overcome the limitations of surveys by providing accurate emission estimates, thanks to continuous sampling of emission plumes. Yet high-precision instruments are too costly to deploy in such networks. Low-cost sensors using a metal oxide semiconductor (MOS) are presented as a cheap alternative for such deployments due to their compact dimensions and to their sensitivity to CH4. In this study, we demonstrate the ability of two types of MOS sensors (TGS 2611-C00 and TGS 2611-E00) manufactured by Figaro® to reconstruct a CH4 signal, as measured by a high-precision reference gas analyser, during a 7 d controlled release campaign conducted by TotalEnergies® in autumn 2019 near Pau, France. We propose a baseline voltage correction linked to atmospheric CH4 background variations per instrument based on an iterative comparison of neighbouring observations, i.e. data points. Two CH4 mole fraction reconstruction models were compared: multilayer perceptron (MLP) and second-degree polynomial. Emission estimates were then computed using an inversion approach based on the adjoint of a Gaussian dispersion model. Despite obtaining emission estimates comparable with those obtained using high-precision instruments (average emission rate error of 25 % and average location error of 9.5 m), the application of these emission estimates is limited to adequate environmental conditions. Emission estimates are also influenced by model errors in the inversion process.
Fichier principal
Vignette du fichier
amt-17-4257-2024.pdf (15.05 Mo) Télécharger le fichier
Origine Fichiers éditeurs autorisés sur une archive ouverte

Dates et versions

hal-04652712 , version 1 (18-07-2024)

Identifiants

Citer

Rodrigo Rivera-Martinez, Pramod Kumar, Olivier Laurent, Gregoire Broquet, Christopher Caldow, et al.. Using metal oxide gas sensors to estimate the emission rates and locations of methane leaks in an industrial site: assessment with controlled methane releases. Atmospheric Measurement Techniques, 2024, 17 (14), pp.4257 - 4290. ⟨10.5194/amt-17-4257-2024⟩. ⟨hal-04652712⟩
0 Consultations
0 Téléchargements

Altmetric

Partager

Gmail Mastodon Facebook X LinkedIn More